MIDI SETUP

The MIDI setup window (Control+M) can be found under the MIDI window menu. In the MIDI Setup window, select the MIDI IN and OUT ports to which the TEO-5 is connected and set the MIDI Channel to match the MIDI channel on the TEO-5.

Once the proper ports and MIDI channel are selected, you should see the current TEO-5 software version at the top of the MIDI Setup window as shown. This confirms that SoundEditor is communicating with the Sequential TEO-5.

To establish a proper MIDI communication. Make sure that the Global Parameters are set MANUALLY (not through the computer) on TEO-5 as follows.

To control the TEO-5 in real-time:

14. MIDI Channel: ALL

18. MIDI Param Snd: NRPN

19. MIDI Param Rcv: NRPN

20. MIDI Control: On

For data communication:

21. MIDI Sysex: USB  or MIDI  - depending on your connection

22. MIDI Syx Cable: USB or MIDI - depending on your connection

Also, please make sure that the Editor and the TEO-5 have the same MIDI channel or TEO-5 MIDI channel is set to ALL.

If you experience connectivity problems please try the following:

• Close all other applications that may be using MIDI ((Midi Ox, Midi Yoke, your DAW, etc.) and then try it again.
• Restart both TEO-5 and the editor.
• If you are using USB hub and having trouble getting on-line, temporarily disconnect all other devices.
• Use 31. Reset Globals function and restart both TEO-5 and the editor.

GLOBAL SETTINGS

The TEO-5 Globals (Control+G) can also be found under the MIDI window menu. Please note that some settings that are necessary for maintaining a proper MIDI communication are disabled and cannot be changed directly for the editor.

MIDI WINDOW MENU

Here you can access all functions that will enable the editor to communicate with the TEO-5 and sync the data by receiving all banks.  

In the MIDI Setup you can configure which MIDI ports should be used to communicate with TEO-5.

Global Settings panel lets you view all TEO-5 Globals.

Important. Changes made by the editor are not saved automatically on TEO-5.

To write global settings changes you need to enter and exit Globals mode directly on the TEO-5 panel.

Bank Panel